Recent content by Mjojo51

Never mind i just sold it and have two other marshall's and don't need to deal with it.

one man's junk is another man's treasure.

I've seen many complaints about this. I figured it was a flawed design. What the heck is on the mind of whoever designed this. No excuse

Weak loop/ verb outputs on clean channel needs modding so the output matches the od channel. Is this common on this model or is there a mod to correct this. For me if i can't fix this i'll just dump it cause i alway run delay through the loop so it doesn't get boosted like when you run it...

just need the clean channel loop and reverb to match the od mix setting. Actually going to dump the amp because of this if there is no way to correct it. I only use loops to add delay and reverbs into the mix so they don't get boosted when ran through the front end when switching to higher gain...

Reverb and loop gets to boosted in od channels so if you set it up for od channel its to weak on the clean. Any mods to balance this messed up design???

Replaced ic-1 and t16 didn't solve problem. oh well

It can wait because besides having two other amps its still usable because i have a delay / reverb pedal to use on the front end but thanks for the advise. Not to mention i don't get to gig that much anymore unfortunately.

Being on ssi doesn't get me food and shops repairs on the same month so it will have to wait for now unless i figure it out or get a wind fall.

Hell i'll get some of those and give it a shot, i've gotten lucky before. Thanks

Thanks. l pondered those along with a couple other components

Screw it i'll use a front end verb/delay till i can afford to fix it and have it sit in a shop for a week or two.

So i guess the problems in the return part of the circuit. fun

Trying to follow marshall schematic's sucks.

The second part of your test of plugging in to the return jack produces no sound. the first part into the send works fine through the second amp or this amp